PAE TP-35 Reverse Osmosis Storage Tank Powder Coated Steel 9.2 Gal

The PAE TP-35 is built with FDA approved materials. The water storage chamber features a virgin polypropylene liner, high-grade chlorobutyl diaphragm and stainless steel 1/4″ MPT water connection. The diaphragm is post cured to ensure that your water is tasteless, odorless and contaminant free. The tank is built with a sealed brass air valve and o-ring sealed cap to ensure a leak-free air chamber.
Note: Please refer to the chart under the documentation/videos tab for information regarding capacity. The volume stated is total capacity, not water storage volume.
Specifications:

• Stainless steel water connection
• High-grade chlorobutyl diaphragm
• Virgin polypropylene liner
• Two part epoxy primer, polyurethane paint finish
• NSF-58 and CE approved
• Also known as PAE TKE-TP35

Reverse Osmosis Tank Maintenance and Accessories:

A tank shut-off valve is necessary to connect the tank to your reverse osmosis system and control the flow of water into and out of the tank. The valve is also essential for performing system service or maintenance. If your RO system uses 1/4″ OD tubing to connect to the tank, select the LFPP4VFE4
valve. If your system uses 3/8″ OD tubing select the PP6VFE4-MG
valve.
For optimal performance, it is necessary to keep a pre-charge of approximately 7 psi in your tank. Most automotive tire pressure gauges either do not read below 10 psi, or are not very accurate at pressures this low. 54846 Tank Pressure Gauge
reads pressures between 0 and 20 psi, making it perfect for RO tank maintenance.
The RO tank should be sanitized before initial use and during every filter change. The Reverse Osmosis Sanitizing Maintenance Kit features Sani-System, an EPA & NSF certified sanitizer, making it a great alternative to using chlorine bleach. The kit also includes a syringe for application of the sanitizer.